Oklahoma Affiliate of ABANA
♦ October 2016 Newsletter
♦ October 2016 B&W Newsletter
♦ 2016 SCABA Conference
|Workshops||Demos||Videos||Member Gallery||Newsletter||Scholarships||Tailgate||Membership Application|
These swage blocks are new castings from a good grade of cast iron.
Size: 12-1/4 x 7-1/2 x 3-1/2” thick. 65 lbs
Swage Block Notes: You will have to do some light grinding on the swage block at the parting line. The as-cast edges need to be radius ground as well before use. The club felt that most folks would rather do their own clean up, and it also helps us keep the cost down. Most of the depressions cast pretty clean; some take a little grinding to make really smooth. Typical of a sand cast part. The one in the photo has only been wire brushed – no other grinding -- it's as cast. The amount of grinding and polishing you do is your choice.
Photo Note: Pictured is one block; it simply took two photos to show both sides. There are patterns on all 6 faces of the cube.
You will need to send your address with zip code to Bill Kendall so he can calculate the shipping costs.
We try to have blocks on hand at Saltfork monthly club meetings – no shipping cost.
For more information about the blocks please contact:
|Support *Artist-Blacksmith's Association of North America|
|The Artists-Blacksmith's Association of North America was established in 1973 and since its inception has played a major role in the recognition and resurgence of Artist-Blacksmiths in North America.|
This site was last updated: 26 Sept. 2016